LESLIE: Rich in Illinois needs some help with a painting project. Tell us what you’re working on.
RICH: I’m working on a house that I’ve been living in since 1988. And the bottom four sections of my steel siding keep peeling. It’s like a 30-foot-long piece. Each piece is 8 inches wide. And it has a wood-grain pattern on it; looks like it’s been stamped. And every two years, I approach this project. First time, I took a wire brush to it and knocked all the loose off and primed it. And two years later, I was doing it again.
And every year, I try a different method. I tried a wire wheel on a drill. Last year, I took an air compressor and a hose and a drill and a wire wheel and went down to the bare metal.
RICH: And went to the paint store and they gave me some primer and some paint. And seemed like everything I try – I wash it with paint thinner sometimes before I do it. Sometimes I just use soap and water. I always make sure it’s a nice, dry day – about 80 degrees – when I paint it. And it seems to always come back about every two to three years.
I know it should be replaced but I kind of like the siding. But it’s steel and it’s – the company is no longer in business now and so the warranty is up on it.
TOM: And there’s different qualities of steel. So even if it had a rust-resistant finish on it, it could have just worn off. And I wonder if whatever process they used is what’s causing the paint to not stick.
When you prime it, are you using an oil-based primer or are you using an alkyd primer?
RICH: Both. I’ve used both. I don’t know if it’s the primer that I use or if it’s – I’ve even went down to no paint at all and just the galvanized showing and – I don’t know. I don’t know what it – I don’t know if it’s the primer or what I’m using to wash the siding with that’s causing it or it’s the paint. I tried four or five different kinds of paint on this and primer.
TOM: What I would do – I mean if I was priming it – and you may have done this already. But what I would do is I would use same manufacturer’s primer and paint. So, for example, I don’t think you can go wrong with Rust-Oleum. That’s pretty much one of the best metal paints of all.
I would use the red Rust-Oleum primer – the oil-based primer – and I would let it thoroughly dry after you knock off all the loose paint and sand it and make sure the surface is ready to accept it. But I would use the oil-based Rust-Oleum primer which, by the way, takes forever to dry. Depends on the weather but three or four or five hours is not unusual. And then, I would use the Rust-Oleum top coat. Again, oil-based. And I rarely recommend oil-based but in this situation, I think that’s what’s going to give you the best adhesion.
Now, Rich, there’s one other piece of advice that we could offer you on this and it comes from a process that’s very – that’s done very often when people work on cars. There’s a product called Prep-Sol – P-r-e-p-S-o-l. And it’s a solvent that’s designed to be applied to bare metal before the primer. You might want to look that up as – I don’t know what – you said you were using a solvent. I don’t know if you were using mineral salt – mineral spirits or something like that – but this is specifically made for it. Just Google it. It’s called Prep-Sol – P-r-e-p – S-o-l. And it’s a cleaning solvent.
RICH: OK. Do I apply it with a brush or a rag or …?
TOM: You apply it with a rag. Use a clean cloth and you apply it – you soak it in with the cloth.
RICH: Yeah, I’ll try that. Thank you.
TOM: You’re welcome. Good luck with that project. Thanks so much for calling us at 888-MONEY-PIT.