Burn Hole on a Laminate Countertop

  • Transcript

    LESLIE: Jay in North Carolina is dealing with a supreme oopsie on a countertop. What happened?

    JAY: Well, I don’t know. I purchased the property about a year ago and actually, I have my son living there. He’s graduating from a college in the Raleigh area and he’s living in that – in the apartment and it’s wonderful. The only problem is there’s a burn hole on the laminate countertop.

    TOM: Now, Jay, there’s a story behind that but of course, your son hasn’t – yeah, your son hasn’t coughed it up yet, I’m sure.

    JAY: No, well, no, no. This was before he moved in but hey, it’s OK.

    TOM: Alright.

    JAY: My point is it’s right out in the middle of the thing, so it’s this big burn hole. And I was just wondering, is there a way I can cut it out and then put another patch of laminate over it? It’s in butcher-block style.

    TOM: Well, the good news is that you could do a built-in countertop and – a built-in cutting board or a built-in piece of marble. And if you do it in something that’s complementary – look, it may be a little bit weird to have a cutting board on the finished side of the countertop like that but it’ll certainly look like it was always intended to be there and you’ll get away with it.

    The other thing that you could do is you could relaminate the countertop. You can’t fix the burned surface, because the plastic’s been damaged, so that’s not something that’s possible. You can’t cut in a new piece of laminate, because it’ll be patchy and it’ll look lousy. What you could do is you could put a new piece of laminate across the entire surface. So you’re keeping the structure of the countertop but you’re gluing a new piece of laminate on top of that.

    Installing a laminate is not that difficult if you have some basic DIY skills. You would scuff up the original surface, you would apply contact cement to both the new laminate and the old laminate. You would lay it down and you would press it from the middle on out to get out any air bubbles and rub it all out. And then with a router and a special laminate-trimming bit, you would trim the laminate edge very clean to the existing edge of the top and you’d have a brand-new laminate surface when you were all done.

    It’s best if you can take the old top off temporarily to do this so that you don’t have to work around walls and that sort of thing. But it’s not hard to do and that’s one way to have to – to get it repaired without having to physically replace the whole thing. Does that make sense?

    JAY: Excellent idea. Thank you so much. Appreciate your help.

    TOM: Thanks so much for calling us at 888-MONEY-PIT.

Leave a Reply