Baseboard Molding Against an Uneven Floor

Submitted By
1 expert, 0 community

Is there a way to pattern molding against an uneven floor, using plastic molding as the trim, similar to cutting tile pieces for not full pieces?
This is between drywall and a concrete floor in the garage.

Post new answer

Type the characters you see in this picture. (verify using audio)
Type the characters you see in the picture above; if you can't read them, submit the form and a new image will be generated. Not case sensitive.


I'm not sure what you mean by "similar to cutting tile pieces for not full pieces" however, if you are asking how to handle gaps under baseboard molding because the molding is not flexible enough to bend to cover itself, the solution is to use a 2nd piece of more flexible molding over the first..  This is easily accomplished by using "shoe" molding" which would run along the base of the baseboard molding but is very flexible and can follow the gaps in the floor.

Hope this helps!

1 user found this helpful
You voted
Was this answer helpful?