LESLIE: Jeff in Iowa needs some help with a low-flow showerhead. In true Seinfeld fashion, you’re just not getting a good wash going?
JEFF: No. No, I’m not. My house is a 1978 ranch. We’ve lived here about 10 years. I’ve always had good water – what I felt was reasonably good water pressure. Still has the original showers and showerheads in it, so I decided to upgrade everything to more eco-friendly stuff. Replaced the toilets, no problem. But the showerheads, I put these low-flow showerheads on and it’s like the water is just barely – I expected some decrease in performance, obviously, but the water is just like falling out of them. It’s not spraying out like I would expect.
TOM: Is this just happening at one showerhead, Jeff, or is it happening at several showerheads?
JEFF: Two showerheads.
TOM: Two showerheads, OK. So, we can rule out any kind of blockage because it wouldn’t be happening to both at the same time.
Now, what kind of showerheads did you put in there? Can you tell me the brand?
JEFF: Well, the first one was the home improvement store’s brand showerhead. The second one I’ve got is a Waterpik. It’s not the highest end. And I thought maybe I just went too cheap on the first one, so I went kind of middle-of-the-road. Made it – I didn’t know if I maybe needed to upgrade even more or just go back to the old showerheads.
TOM: So, when you install a low-flow showerhead and you didn’t have one before, you are correct in that you’re going to get a reduction in the power of the shower that perhaps you were used to.
Now, there should be an adequate amount of water. And the fact that you’re not feeling that means that maybe you don’t have the right showerhead or there’s something wrong with the installation. I’d like to, for the purpose of this conversation, rule out the installation, rule out any clogging, although that is entirely possible. And you might want to take it off to look behind it to make sure that’s the case.
But what I would recommend is that you upgrade the showerhead to a name brand like a Moen or perhaps a Delta. Because these guys spend a lot of time and a lot of money engineering their showerheads so that they don’t decrease performance when they save you water. And the other thing to look for is a certification called WaterSense. And it’s sort of like ENERGY STAR for appliances but it’s like measuring water efficiency for faucets and showerheads.
JEFF: I will definitely give that a try because what I’ve got going on now, it takes me so long to shower and get film and stuff, I might as well use the high-flow and …
TOM: Not going to work, right? Yeah.
JEFF: Then in and out, you know? It takes the lumps. So, yeah, it’s not doing the trick. I will look into the more expensive one and see what that does for me.
TOM: Alright. Yeah, you can always take it back if that doesn’t work. But take a look at the installation first, just to be sure. Make sure you don’t have any plumbing tape that got jammed in there or anything of that nature, OK?
JEFF: OK. Sounds good. Thanks, guys.