Painting Kitchen Cabinets: Step by Step

Give kitchen cabinets a facelift with a fresh coat of paint

Even if you have a nice looking kitchen, consider painting kitchen cabinets that have a few minor scratches or marks on them.   Painting kitchen cabinets is a fairly easy project that can add life to cabinets that need a pick up in the appearance department, but that operate perfectly well.

Materials:

  • Screwdriver
  • Newspaper
  • TSP (trisodium phosphate)
  • Sponge
  • Bucket
  • Sandpaper (a coarse and a fine grit)
  • Painter¹s TapePainting Kitchen Cabinets: Step by Step
  • Primer (water or oil-based)
  • Oil-based Paint (satin,gloss or semi-gloss)
  • 2 1/2-inch Natural Bristle Brush
  • Paint Tray with Liners
  • Thin Roller Sleeves

Painting Kitchen Cabinets:

Step 1:  Remove all kitchen cabinet drawers drawers; ­­ some will just slide out, others will need to be tipped forward or back to be released from any side-mounted or bottom-mounted slides. Also take out any adjustable shelves before painting kitchen cabinets.

Step 2: Before painting kitchen cabinets, remove door hinges and drawer pulls. Put them and their screws in a small plastic bag. If you¹re installing new hardware, measure the hole spacing so you buy the correct size. As you take off doors and drawers, number them with a permanent marker. On doors, put a number behind the hinge so it won¹t show when you put the hinge back; on drawers, mark the bottom.

Step 3: Wash inside and outside the kitchen cabinets with TSP and warm water. Don¹t forget to clean the drawers and shelves you removed earlier. Let the surfaces dry after rinsing. Fill dents and scratches with wood filler, then lightly sand the surfaces. Tape off sections that you do not want painted. Also tape newspaper onto the counters and on the floor.

Step 4: Prime any interior kitchen cabinet surfaces to be painted first. Since the insides only show when doors or drawers are open, It is only necessary to paint in as far as the trim. A mini roller helps get into corners. Use a brush to get the drawer faces¹ inside surfaces.

Step 5: Use a roller to coat kitchen cabinet doors, kitchen cabinet sides and removable shelves. Paint the edges first and then immediately paint the broad surfaces in the direction of any grain.

Step 6: Paint the cabinet face frames with a brush. Be sure to paint in the direction of any grain. Paint any inside edges first, then the outer surface of the kitchen cabinet.

Finish Up painting kitchen cabinets:

Once priming is done, begin painting the kitchen cabinets with the first paint coat, following the same steps after 24 hours. If a second coat is needed, paint after another 24 hours. When the paint is dry, install your hardware, doors and drawers on your newly painted kitchen cabinets. 

Post new comment

The content of this field is kept private and will not be shown publicly.
Type the characters you see in this picture. (verify using audio)
Type the characters you see in the picture above; if you can't read them, submit the form and a new image will be generated. Not case sensitive.

Comments

Sanding down the kitchen

Sanding down the kitchen cabinet surfaces is a must. You